G3 Interface Unit Type 1045 Installation - Gestetner B003 Service Manual

1.1.4 G3 INTERFACE UNIT TYPE 1045 INSTALLATION

[B]
[A]
!
CAUTION
Before installing this option, do the following:
1. If there is a printer option in the machine, print out all data in the printer
buffer.
2. Press the operation switch to enter standby mode. Make sure the power
LED is not lit, then turn off the main switch and disconnect the power
cord and the network cable.
1. Remove the small cover [A] (1 screw) and the connector [B].
2. Remove the rear cover [C] (2 screws), the rear upper cover [D] (2 screws) and
the rear lower cover [E] (4 screws).
3. Remove the FCU cover [F] (2 screws) and controller unit (2 screws).
SM
[D]
B360I101.WMF
[E]
B360I104.WMF
1-7
FAX UNIT
B360I102.WMF
[F]
B003/B004/B006/B007
[C]