Gestetner B003 Service Manual page 669

BIT SWITCHES
I/O rate
G4 Communication Parameters
Compression mode MMR: MMR compression
Resolution
Width and
reduction
Transfer
Confidential
Other parameters
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02
No FUNCTION
0-3 Not used
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
5 Not used
B003/B004/B006/B007
0: 0 ms/line 10: 10 ms/line
25: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
MR: MR compression
MH: MH compression
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
T: Transfer
- : Other
C: Confidential
- : Other
The following information is shown in 6-bit format. Bit 1 is the first
bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing
Bit 3 - Not used
Bit 4 - mm/inch conversion 0: Off, 1: On
Bit 5 - Engine type
Bit 6 - Document resolution unit 0: mm, 1: inches
Do not change the settings.
1: A file that had a communication error will not be
erased unless the communication is successful.
Do not change the setting.
3-12
0: Off, 1: On
0: On, 1: Off
0: mm, 1: inches
COMMENTS
SP No. 1-101-003
SM