Stack Height Sensor Replacement - Gestetner B003 Service Manual

STACK HEIGHT SENSOR REPLACEMENT

4.4 STACK HEIGHT SENSOR REPLACEMENT
[B]
[A]
A681R504.WMF
A681R503.WMF
[C]
[E]
[G]
[I]
[F]
[D]
[H]
A681R505.WMF
1. Remove the front cover.
2. Remove the shift tray lift motor [A] (2 screws).
NOTE: The shift tray must be pulled up to remove the two screws.
3. Remove the rear cover.
4. Remove the exit motor unit [B] (2 screws, 1 spring, 1 timing belt).
5. Remove the lower exit guide [C] (4 screws).
6. Remove the front and rear end fence holders [D,E] (1 screw each).
7. Remove the end fence [F] (1 snap ring).
8. Remove the stack height sensor cover [G] (1 screw).
9. Remove the stack height sensor bracket [H] (1 screw).
10. Replace the stack height sensor [I] (1 connector).
B003/B004/B006/B007 13-22 SM