Gestetner B003 Service Manual page 236

SERVICE PROGRAM MODE
SP5 Mode Number
5129*
5131*
5150*
⇒
5212*
3*
4*
5302* 2*
5501* 1*
B003/B004/B006/B007
F Paper Size Selection
Paper Size Type Selection
By-Pass Wide Paper
Mode
Page Stamp
Duplex Printout Right/Left
Position
Duplex Printout High/Low
Position
Set Time
PM Alarm Interval
Function and [Setting]
Selects the "F" paper size
[0~2 / 0 / 1 step]
0: 8" × 13" (L)
1: 8½" × 13" (L)
2: 8¼" × 13" (L)
Selects the paper size (type) for both originals
and copy paper.
[0~2 / DIP SW setting / 1 step]
0: Japan
1: North America
2: Europe
After changing the setting, turn the copier off and
on. If the paper size of the archive files stored on
the HDD is different, abnormal copies could
result. Perform SP5-822 and ask the customer to
restore the archive files.
Determines whether the transfer sheet from the
by-pass tray is used or not.
0: Off, 1: On
Normally, the paper length from the by-pass tray
is limited to 600 mm, but this can be extended
with this SP to 1260 mm.
Determines how horizontal printing is executed
during duplex printing. Sets the upper right corner
of the front side and the upper left corner of the
backside so the starting points for horizontal
printing are the same on both sides DFU.
[–10~+10 / 0 / 1 mm step]
–10: Extreme right
+10: Extreme left
Determines how vertical printing is executed
during duplex printing. Sets the upper right corner
of the front side and the upper left corner of the
backside so the starting points for vertical printing
are the same on both sides. DFU
[–10~+10 / 0 / 1 mm step]
–10: Extreme top
+10: Extreme bottom
Adjusts the RTC time setting for the local time
zone.
[–1440~+1440 / 1 min. step]
Example: For Japan (+9 GMT), enter 540 (9
hours x 60 min.)
Sets the PM alarm interval.
[0~255 / 0 / 1 step]
0: Alarm off
1~255: Alarm goes off when
Value (1~255) x 1000
5-30
Rev. 08/2003
≥
PM counter
SM