Ieee1394 Interface (G) - Gestetner B003 Service Manual

IEEE1394 INTERFACE (G590)
1.6 IEEE1394 INTERFACE (G590)
!
CAUTION
Unplug the main machine power cord before starting the following
procedure.
NOTE: To install the IEEE1394 option, the printer option (B361) must be installed
first. Please refer to section 1.2 for details of the printer option installation
procedure.
1. Remove the left rear cover [A] (2 screws).
2. Remove the controller board [B] (2 screws).
3. Remove the HDD [C] (2 connectors,
3 screws).
4. Remove the IEEE1394 cover [D].
5. Attach the IEEE1394 board [E] to the
controller board [F] (2 screws).
6. Re-install the HDD and put back the
controller board.
7. Remove the wire handle on the
controller panel board and place it on
the back side of the left rear cover.
8. Replace the left rear cover.
B003/B004/B006/B007
[B]
[C]
[D]
1-10
[A]
B361I101.WMF
B361I102.WMF
[E]
[F]
B361I106.WMF
SM