Scanner Service Mode; Scanner Program Mode Table - Gestetner B003 Service Manual

3.3 SCANNER SERVICE MODE

3.3.1 SCANNER PROGRAM MODE TABLE

Service Table Key
Notation
[range / default /
step]
italics
*
DFU
SP1 Mode Number
1001 1 Model Name
2 Scanner Firmware
Version
3 Scanner Firmware
Number
4 Detail Model Name
1002 Error Log Display
1003* FTP Port Number
1004* Compression Type
1005* Erase Margin
1006* Auto Reset Timer
SM
What it means
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with each
key press.
Comments added for your reference.
This value is stored in NVRAM. After a RAM reset, the default
value (factory setting) is restored.
Denotes "Design or Factory Use". Do not change this value.
Displays the model name.
Displays the scanner firmware version.
Displays the firmware's part number.
Displays the detail model name.
Displays the error log data.
Changes the FTP port number.
After changing this value, do the following:
1. Run the Registry Editor
2. Access
/HKEY_LOCAL_MACHINE/SOFTWARE/
Ricoh/NetworkScanner
3.
Change the value of 'PortNo' to this SP
mode's value
[0 – 65535 / 3670 / 1 step]
Selects the compression type for binary picture
processing.
[1: MH, 2: MR, 3: MMR]
Creates an erase margin for all edges of the
scanned image.
If the machine has scanned the edge of the
original, create a margin.
[0 – 5 / 0mm / 1mm step]
Adjusts the auto reset timer for the scanner
function.
If this is "0", the auto reset function is disabled.
[0, 10 – 99 / 60s / 1s step]
3-3
SCANNER SERVICE MODE
Function and [Setting]
B003/B004/B006/B007