Gestetner B003 Service Manual page 239

Rev. 04/2002
SP5 Mode Number
5812* 2* SMC Report Transfer Fax.
No.
5816* 1 CSS Function On/Off
2 CE Call
5821* CSS PI Device Code
⇒
5824 NVRAM Data Upload
⇒
5825 NVRAM Data Download
5828* 25* Software Switch
26* Network Operation Mode
Setting
27* Network Syslog Server
Address Setting
28* Network Time Server
Address Setting
29* Network DNS Server
Address Setting
30* Network Directprint Port
Number Setting
31* Network IPP Timeout
Setting
32 Network IPX Address
Setting (NetWare)
33* Network Remote Printer
Number Setting
(NetWare)
34* Network Software Switch
Setting (NetWare)
35* Network Transport
Protocol of Print Server
Setting (NetWare)
SM
SERVICE PROGRAM MODE
Function and [Setting]
Use this to input the fax number of the service
representative This number is printed on the
Counter Report (UP: System No. 19)
Press the key to input a pause.
Press the "Clear modes" key to delete the
telephone number.
Japan Only
0: Off, 1: On.
Japan Only
0: Start, 1: Finish
Selects the PI device code. DFU
[0~4 / 0 / 1 step]
Uploads the UP and SP mode data (except for
counters and the serial number) from NVRAM on
the control board to a flash memory card. (
5.3.1)
Downloads the content of a flash memory card to
the NVRAM on the control board. (
After executing this SP, switch the copier off and
on.
Sets the reference for the network software.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
Sets the TCP operation mode for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
Sets the syslog server address for the network.
[00000000~FFFFFFFFh / 7F000001h / 1 hex unit step]
Sets the time server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
Sets the DNS server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
Sets the directprint port number for the network.
[1024~65535 / 9100 / 1 step]
Sets the IPP timeout for the network.
[30~65535 / 900 / 1 step]
Sets the IPX Address.
Sets the remote printer number for the network.
[0~254 / 0 / 1 step]
Sets the software switch for the network.
[0000~FFFFh / 0003h / 1 hex unit step]
Sets the transport protocol of print server for the
network.
0001h: TCP & IPX
0100h: TCP& IPX (Priority: IPX)
0102h: TCP Only (Priority: TCP)
0001h: IPX Only
5-33
5.3.2)
B003/B004/B006/B007