Gestetner B003 Service Manual page 683

BIT SWITCHES
Scanner Switch 0E
No FUNCTION
0 Wait time for the next page
when scanning a book original
into memory
0: 60 s
1: 30 s
1 Scan resolution unit
0: mm
1: inches
2 ADF jam alarm display time
0: 60 s
1: 30 s
3-7 Not used
Scanner Switch 0F
No FUNCTION
0 Image rotation before
transmission (A4/LT sideways)
0: Disabled
1: Enabled
1 Not used
Image rotation before
2
transmission (A5/HLT
lengthwise)
0: Disabled
1: Enabled
3-7 Not used
B003/B004/B006/B007
COMMENTS
This bit determines how long the machine waits for
the next page when scanning a book original for
memory transmission. If this timer expires, the
machine transmits all the pages scanned so far as
one document.
Note: In immediate tx or parallel memory tx, the wait
time for the next page is 10 s.
This bit determines which resolution unit will be
used for scanning a fax message.
Default setting: mm
The bit is only effective when bit 0 of scanner bit
switch 0C is "0".
This bit determines how long the machine displays
the ADF jam alarm after a jam occurred.
Do not change the settings.
COMMENTS
This bit determines whether the machine rotates the
scanned image by 90 degrees before transmission.
If this bit is set at 1, A4 (LT) sideways images (297
mm width in the protocol) will be transmitted as A4
(LT) lengthwise images (216 mm width in the
protocol).
Do not change the setting.
This bit determines whether the machine rotates the
scanned image by 90 degrees before transmission.
If this bit is set at "1", A5 (HLT) lengthwise images
will be transmitted as A4 (LT) width images (216
mm width in the protocol).
Do not change the setting.
3-26
SP No. 1-102-015
SP No. 1-102-016
SM