Gestetner B003 Service Manual page 713

BIT SWITCHES
G4 Internal Switch 05
No.
0-1 Not used
Protocol ID check
2
0: Yes 1: No
3-7 Not used
G4 Internal Switch 06 - Not used (do not change these settings)
G4 Internal Switch 07 - Not used (do not change these settings)
G4 Internal Switch 08 - Not used (do not change these settings)
G4 Internal Switch 09 - Not used (do not change these settings)
G4 Internal Switch 0A - Not used (do not change these settings)
G4 Internal Switch 0B - Not used (do not change these settings)
G4 Internal Switch 0C - Not used (do not change these settings)
G4 Internal Switch 0D - Not used (do not change these settings)
G4 Internal Switch 0E - Not used (do not change these settings)
G4 Internal Switch 0F - Not used (do not change these settings)
G4 Internal Switch 10 (Dch. Layer 1)
No.
0-5 Not used
INFO1 signal resend
0: Resend 1: No resend
6
7 Not used
G4 Internal Switch 11 (Dch. Layer 2)
No.
0 Not used
Type of TEI used
0: Dynamic TEI 1: Static TEI
1
Static TEI value
2-7
G4 Internal Switch 12 - Not used (do not change these settings)
B003/B004/B006/B007
FUNCTION
FUNCTION
FUNCTION
Do not change these settings.
The Protocol ID is in the CR packet.
Do not change these settings.
Do not change these settings.
0: Some DSUs may not reply to the INFO1
signal with INFO2, if there is noise in the
INFO1 signal accidentally. Try changing
this bit to 0, to resend INFO1 before the
machine displays "CHECK INTERFACE".
Do not change these setting.
Do not change these setting.
This is normally fixed at 0. However, some
networks may require this bit to be set at 1
(see below). In this case, you may have to
change the values of bits 2 to 7.
Store the lowest bit of the TEI at bit 7 and the
highest bit of the TEI at bit 2.
Example: If the static TEI is 011000, set bits 3
and 4 to 1 and bits 2, 5, 6, and 7 to
0.
3-56
COMMENTS
COMMENTS
COMMENTS
SM