Gestetner B003 Service Manual page 596

CONTROLLER FUNCTIONS
4.2.7 STAPLING
Stapling is available when the two-tray (2250-sheet) finisher or 1000-sheet finisher
is installed.
The finishers have the following stapling positions.
• Depending on the paper orientation, the image may have to be rotated. The
image rotation is done by the controller.
• There is a limit for the number of sheets which can be stapled. If a job has more
than this number, it will not be stapled.
4.2.8 PUNCHING
Punching is available only when the punch kit is installed with the two-tray finisher.
The number of holes (2, 3, or 4 holes) depends on the type of punch kit.
• There is only one punch position available, so the relationship between the
punching position and the printed image depends on the paper feeding
orientation and image rotation.
B003/B004/B006/B007
1000 Finisher
Paper Feed Direction
(Printed side)
2 Tray Finisher
Paper Feed Direction
(Printed side)
2 Tray Finisher
Paper Feed Direction
(Printed side)
4-6
Stapled 2 places
B362D510.WMF
Punching Position
B362D511.WMF
SM