REG-LL_EN.book Page 97 Wednesday, September 14, 2011 12:03 PM
5
Install the Print Drum (Cylinder).
Align the
mark with the
and position the Print Drum (Cylinder) horizontal
relative to the guide.
Note:
• If you manually rotate the Print Drum (Cylinder),
make sure to rotate it so that the
marks meet shown as below after the installa-
tion.
6
Return the units to the original posi-
tions.
Place the Print Drum (Cylinder) into position, and
then close the Front Cover.
mark on the guide
and
Removing and Installing the Print Drum (Cylinder)
Replacing and Disposing Consumables
97