Clearing The Tc Or Mc For Each User - Riso EZ Series User Manual

REG-LL_EN.book Page 83 Wednesday, September 14, 2011 12:03 PM

Clearing the TC or MC for each user

You can clear the current TC or MC for each user. You can also clear the counts of either TC or MC for all users in
a single procedure.
Important!:
• After the counter is cleared, it cannot be recovered.
• The administrator must be registered in advance in the "Create User". ( p.78)
1
Press the
number.
The item numbers are as follows:
• Reset Total Counter: 85
• Reset Master Counter: 86
2
Press the [
The user number entry mode is activated.
3
Enter a user number using the Print
Quantity keys.
To clear the total count (master count) for
all users at a time, follow the steps below:
1)
Input "00" in the user number mode.
2)
Press the [+] key.
The total count (master count) for all users
is cleared and the item number entry
mode is restored.
4
Press the [
"LC--" is displayed, and then the upper-limit count
set is displayed.
key and Enter the item
] key.
] key.
5
Press the [ ] key.
"PC--" is displayed and then the total count is dis-
played.
Note:
• After pressing the [ ] key again, the next reg-
istered user number is displayed without clear-
ing the counts. (Start from step 3.)
6
Press the [C] key.
The TC or MC displayed on the Print Quantity Dis-
play is cleared.
7
Press the [ ] key.
The count is cleared, and the next registered user
number is displayed.
Repeat steps 3 through 9 to continue to clear the
copy/master count for other users.
Important!:
• If you press the key before pressing the
[ ] key, clearance is canceled and the normal
mode is restored.
• If you press the key before pressing the
[ ] key, the clearance is applied and the nor-
mal mode is restored.
Note:
• When the count has been cleared for the last
registered user, the item number entry mode is
restored.
Setting Up User Management
Advanced Features
83