Troubleshooting Tips - Riso EZ Series User Manual

REG-LL_EN.book Page 112 Wednesday, September 14, 2011 12:03 PM
Troubleshooting

Troubleshooting Tips

If any problems occur during printing, check the following items and take appropriate procedures before calling your
dealer (or authorized service representative).
Problem
The machine does not start when the
power switch is pressed.
does not go off even when the
Front Cover is closed.
The Paper Feed Tray cannot be
closed.
The Print Drum (Cylinder) cannot be
placed into position.
112
Troubleshooting Tips
Cause
The power was turned off without
notice of the Sleep status.
Power has been disconnected.
The bottom right of the Front Cover
has not been firmly closed.
• The Feed Paper Tray Guides
have not been widen up to the
limit.
• The power was turned off before
the Paper Feed Tray was lowered
to the bottom.
The Print Drum (Cylinder) was
stopped at an inappropriate position
after rotation.
The Print Drum (Cylinder) has not
been correctly set to the guide.
Action
Try pressing the power switch again.
Before pressing the power switch,
you may want to find out whether the
machine is indeed in the Sleep
Mode, by checking the indicator
on the Control Panel. If the
lit, the machine is in sleep mode.
Press the key to end sleep mode
and to activate the machine.
• Check if the power cord has been
firmly connected to a electrical
outlet.
• Check if the power cord has been
firmly connected to the machine.
• Check if the commercial power
circuit breaker is on.
Firmly close the bottom right of the
Front Cover.
Turn the power on and lower the
Paper Feed Tray to the bottom. Set
the Feed Tray Paper Guide Lock
Lever to , widen the Feed
Tray Paper Guides up to the limit,
and close the Paper Feed Tray.
After manually rotating the drum
(cylinder), make sure that the
mark and the mark meet as
shown.
Set the drum (cylinder) to the guide
correctly.
p.96
key is