Riso EZ Series User Manual page 107

REG-LL_EN.book Page 107 Wednesday, September 14, 2011 12:03 PM
When the indicator [Area *3] blinks
Check error locations and error numbers (Error Number Display) and take the following procedures.
If an error number is not shown, press the [
Location Error No.
No.
c-04
F-03
d-11
d-01
d-02
d-03
d-04
F-01
] key.
Cause
The tray has run out of paper.
Custom-size paper has been placed
on the Paper Feed Tray at the time of
2-Up printing.
The Front Cover is open or has not
been completely closed.
The Print Drum (Cylinder) has not
been set or has not been correctly set.
An inappropriate Print Drum (Cylinder)
has been set.
The Ink Cartridge has not been set or
has not been correctly set.
An inappropriate Ink Cartridge has
been set.
The label on the Ink Cartridge outlet
surface has come off or surface is with
dirt.
A master has not been wrapped
around the Print Drum (Cylinder).
Troubleshooting
Action
Place paper on the Paper Feed Tray.
Custom-size paper does not allow 2-Up
printing.
Press the key and then place regular-
sized paper.
Close the Front Cover completely.
Set the Print Drum (Cylinder) correctly.
p.96
Set an appropriate Print Drum (Cylinder).
p.96
Important!:
• Use a Print Drum (Cylinder) specific to the
machine. Set other Print Drums (Cylinders)
can result in malfunction or any other
troubles.
Set an Ink Cartridge correctly.
p.88
Set an Ink Cartridge specific to the machine.
p.88
Important!:
• Use an Ink Cartridge specific to the
machine.
Using other Ink Cartridges can result in
malfunction or any other troubles.
The label on the Ink Cartridge outlet surface
contains information needed for printing. If the
machine cannot read the information, it does
not operate.
Set an Ink Cartridge that is specific to the
machine and that is with label attachment and
free from dirt.
Place an original and start with the master-
making process.
If you leave the machine without a master
wrapped around the Print Drum (Cylinder),
malfunction may occur. Press the
and then press the key. Or perform
master-making operation to wrap a master
around the drum (cylinder).
Check & Error Display
key,
107