Adjusting The Print Position [Print Position Adjustment]; Adjusting The Vertical Position; Adjusting The Horizontal Position - Riso EZ Series User Manual

REG-LL_EN.book Page 50 Wednesday, September 14, 2011 12:03 PM
Setting up for Printing
Adjusting the Print Position
[Print Position Adjustment]
Use the Vertical Print Position Adjustment keys to adjust the print position in the vertical direction; and use the Hor-
izontal Print Position Adjustment Dial to adjust it in the horizontal direction.
Adjustment range Vertical direction: ±15 mm(±
*For paper of widths over 297 mm(±11
±10 mm(± / ").
3
8
Important!:
• After adjusting the print position, print a proof copy to check the result.
p.48

Adjusting the Vertical Position

Press the / keys to adjust the vertical
position.
key: Each press shifts the print position downward in
steps of about 0.5 mm(
key: Each press shifts the print position upward in
steps of about 0.5 mm(
key: Returns the print paper to the original posi-
tion.
: Shifts the print position downward.
: Shifts the print position upward.
50

Adjusting the Print Position [Print Position Adjustment]

") Horizontal direction: ±10 mm(±
1 /
2
/ "), the adjustment range in the horizontal direction becomes smaller than
11
16
/ ").
1
64
1 / ").
64
3 / ")*
8

Adjusting the Horizontal Position

1
Press the Feed Tray Ascent/Descent
Button to lower the Paper Feed Tray.
2
Turn the Horizontal Print Position
Adjustment Dial beside the Paper Feed
Tray.
Turn the dial upward to shift the print position to the left,
and turn the dial downward to shift it to the right.
You can check the offset amount from the center, through
the scale marks beside the Paper Feed Tray.
on the scale indicates the center.
Important!:
• If you have adjusted the horizontal position, also
adjust the Receiving Tray Paper Guides.
• If you have adjusted the horizontal position, make sure
to reset to the center after printing is finished.