Removing And Installing The Print Drum (Cylinder) - Riso EZ Series User Manual

REG-LL_EN.book Page 96 Wednesday, September 14, 2011 12:03 PM
Replacing and Disposing Consumables
Removing and Installing the Print
Drum (Cylinder)
When replacing with a color drum (cylinder) or dealing with paper jams, remove the Print Drum (Cylinder), take a nec-
essary procedure, and then install the drum (cylinder).
Important!:
• Make sure to place and keep the removed Print Drum (Cylinder) horizontal.
• Keep the power ON while removing or replacing the Print Drum (Cylinder).
• Make sure to place the replaced Print Drum (Cylinder) in the drum (cylinder) case and keep it horizontal.
1
Open the Front Cover.
2
Check that the indicator of the Print
Drum (Cylinder) Release button is
on.
If the indicator is off, press the Print Drum (Cylin-
der) Release button to turn on its indicator.
:Print Drum (Cylinder) Release button
Note:
• With the Master Making Unit pulled out, you
cannot remove the Print Drum (Cylinder).
Place the Master Making Unit into position, and
then press the Print Drum (Cylinder) Release
button.
p.90
96

Removing and Installing the Print Drum (Cylinder)

3
Pull out the Print Drum (Cylinder).
Grasp the Print Drum (Cylinder) Handle and pull out
the Print Drum (Cylinder) until it stops.
4
Remove the Print Drum (Cylinder).
Lift the Print Drum (Cylinder) with both hands to
remove it from the guide.
B
Caution:
• Do not touch the connector on the Print Drum
(Cylinder).
Neglecting this may result in malfunction of the
Print Drum (Cylinder) because of static electric-
ity or other factors.