Riso EZ Series User Manual page 103

REG-LL_EN.book Page 103 Wednesday, September 14, 2011 12:03 PM
When the indicator [Area *3] blinks
Check error locations and error numbers (Error Number Display) and take the following procedures:
Location Error No.
No.
A-06
A-02
Cause
Any obstacle exists under the Paper
Feed Tray or on paper.
A master has not been correctly
wrapped around the Print Drum
(Cylinder).
Action
Check if any obstacle exists under the Paper
Feed Tray or on paper. If an obstacle exists,
remove it.
1)
Pull out the Print Drum (Cylinder).
2)
Press the Print Drum (Cylinder) Release
Lever ( ), hold the edge of the Print Drum
(Cylinder), and turn the Drum (Cylinder) until
the clamp plate (metallic plate locking the
master) comes to the top (
3)
Press the Clamp Plate Release Lever (
to unlock the clamp plate, hold the edge of
the master, and then separate the master
while turning the Print Drum (Cylinder) (
4)
Turn the Print Drum (Cylinder) until the
marks meet.
5)
Set the Print Drum (Cylinder) into the
machine.
6)
Pull out the Master Making Unit and set the
master again.
7)
Place the Master Making Unit into position.
8)
Perform the master-making operation again.
Check & Error Display
Troubleshooting
p.96
).
)
).
103