Riso EZ Series User Manual page 108

REG-LL_EN.book Page 108 Wednesday, September 14, 2011 12:03 PM
Troubleshooting
Location Error No.
No.
d-05
d-08
d-09
d-17
d-07
F-37
b-01
b-22
b-23
b-24
b-33
F-04
Non
F-38
F-39
108
Check & Error Display
Cause
A master roll has not been set or has
not been correctly set.
The Master Making Unit has not been
correctly set.
The Master Making Unit Cover has not
been closed.
An inappropriate master roll has been
set.
The section on the master core is
missing, or it has worn off, or it has
been tilted.
The Master Disposal Box has not been
set or has not been correctly set.
Originals have been placed in the ADF
unit (option) in the Book shadow
editing.
A card has not been set to the Key
Card Counter (option).
Power to the Job Separator (option) is off. Turn on the power to the Job Separator.
The Job Separator (option) has run out
of tape.
A tape jam has occurred in the Job
Separator (option).
An IP address has not been set for the
machine.
The count reached the set upper limit
while an identified user was printing.
The PIN code entered when
registering a user has been already
registered.
A PIN code of a disabled user has
been entered.
Action
Set a master roll correctly and close the
Master Making Unit Cover.
p.90
If a rewound master has been wrinkled or has
worn off, cut the edge of the master straight
and then set the master again.
Set the Master Making Unit correctly.
p.90
Pull out the Master Making Unit and close the
Master Making Unit Cover completely.
p.90
Set a master roll specific to the machine.
The section on the master core contains
information needed for making masters.
If the machine cannot read the information, it
does not operate. Set a dedicated Master Roll
that has the mark and is free from wear
and tilt.
Set the Master Disposal Box correctly.
p.93
Press the key and then place an original
on the Glass Platen.
Or quit the Book shadow editing.
Set a card to the Key Card Counter.
Set new tape to the Job Separator.
Check the Job Separator and remove the
jammed tape.
Using the Custom Setting mode, set the IP
address for the machine.
p.75
Press the key to release the error. Then
contact the administrator to clear the TC or
MC.
Press the key to release the error. Then
enter an unregistered PIN code.
Press the key to release the error.
p.40