Riso EZ Series User Manual page 92

REG-LL_EN.book Page 92 Wednesday, September 14, 2011 12:03 PM
Replacing and Disposing Consumables
Tip:
• If you cannot insert the leading edge of the
master well, use the following procedure:
1) Raise the Master Guide Flap.
Turn the wheel beside the Master Guide Flap
inward to raise the Master Guide Flap.
2) Pull out the Master Roll up to the line
indicated by the arrows.
3) Lower the Master Guide Flap to the
original position.
10
Return the units to the original posi-
tions.
Close the Master Making Unit Cover, return the
Master Making Unit to the original position, and
then close the Front Cover.
92
Replacing the Master Roll