Port Lacpmode All; Port Lacptimeout (Interface Config) - Cisco Small Business 200 Series User Manual

Port Management
Link Aggregation
NOTE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Command
port-channel
adminmode
LACP mode is for the physical interface, when this port is configured as a member
of static LAG then this configurable does not apply and this port can become an
active member of the LAG. The LACP mode must be enabled for this port to
participate in a dynamic LAG. If this mode is off and this port belongs to a dynamic
LAG this port will fail to become an active member.

port lacpmode all

This command enables Link Aggregation Control Protocol (LACP) on all physical
ports. Use the no form of command to disable LACP on all ports.
port lacpmode all
no port lacpmode all
Command Modes
Global Config
Related Commands
Command
port lacpmode
port lacptimeout
(Interface Config)
port lacptimeout
(Global Config)
port-channel
adminmode

port lacptimeout (Interface Config)

This command sets the timeout on a physical interface of a particular device type
(actor or partner) to either long or short timeout. Use the no form of command to
set the timeout to its default value on a physical interface of a specific device type
(actor or partner).
Description
Enables a LAG.
Description
Enables LACP on a port.
Sets the timeout on a physical interface of a particular
device type.
Sets the timeout for all interfaces of a particular device
type.
Enables a LAG.
3
203