Poe Power Management - Cisco Small Business 200 Series User Manual

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Command
poe power limit
poe priority
poe
usagethreshold
show poe
show poe port
configuration
show poe port

poe power management

Use this command to set the power management as dynamic or static. Use the no
form of the command to reset it to its default value.
poe power management {dynamic-with-priority | static- with-priority}
no poe power management
Syntax Descriptions
Parameter
dynamic-with-
priority
Description
Sets the method for power management.
Configures the port priority level for the delivery of power
to an attached device.
Configures the system power usage threshold level at
which a trap is generated and a message is logged.
Displays the global configuration, and information about
each device connected to the PSE port(s).
Displays per-port PoE configuration.
Displays per-port PoE status.
Description
Power management is done by the PoE controller. Power
is supplied to devices as long as the consumption is within
the configured limit and priority. There is no pre-allocation
of power. A port with a higher port priority is given
preference when the switch supplies power to multiple
ports. If two or more port priorities are equal, the port with
the lower port number is given preference.
2
44