VLAN Management
VLAN
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
switchport access vlan
Use this command to configure the VLAN ID when the interface is in access mode.
(In Access mode, the port belongs to one or more VLANs, and each VLAN is user-
defined as tagged or untagged (full 802. 1 Q mode).) To reset the parameter to the
default value, use the no form of this command.
switchport access vlan vlan-id
no switchport access vlan
Syntax Descriptions
Parameter
vlan-id
Default
The VLAN ID of the default VLAN.
Command Modes
Interface Config
Related Commands
Command
switchport mode
switchport general acceptable-frame-type tagged-only
Use this command to configure the Acceptable Frame Type Admit Only VLAN
Tagged for a General port. To enable untagged frames at ingress, use the no form
of this command.
switchport general acceptable-frame-type tagged-only
no switchport general acceptable-frame-type tagged-only
Default
Both tagged and untagged frames are accepted.
Description
The VLAN ID.
Description
Configures the VLAN membership mode of a port.
4
220