Set Mld Groupmembership-Interval; Set Mld Maxresponse - Cisco Small Business 200 Series User Manual

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference

set mld groupmembership-interval

Use this command to set the MLD Group Membership Interval time on a VLAN. The
Group Membership Interval is the amount of time in seconds that a switch waits for
a report from a particular group on a specific interface before deleting the
interface from the entry. Use the no form of the command to reset it to the default
value.
set mld groupmembership-interval vlan-id 2-3600
no set mld groupmembership-interval vlan-id
Syntax Descriptions
Parameter
vlan-id
2–3600
Default
group membership interval—260 seconds
Command Modes
VLAN Config
Related Commands
Command
show
mldsnooping

set mld maxresponse

Use this command to set the IGMP Maximum Response time on a particular VLAN.
The Maximum Response time is the amount of time in seconds that a switch will
wait after sending a query on an interface. Use the no form of the command to
reset it to the default value.
set mld maxresponse vlan-id 1-65
no set mld maxresponse vlan-id
Description
The ID of the VLAN to configure.
The interval. The range is 2–3600 seconds.
Description
Displays MLD Snooping information.
7
316