Set Mld Mrouter - Cisco Small Business 200 Series User Manual
Advanced smart switch command line reference
Hide thumbs
Also See for Small Business 200 Series:
- Administration manual (337 pages) ,
- Quick start manual (72 pages) ,
- Administration manual (202 pages)
Table of Contents
Advertisement
Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Parameter
0–3600
Default
expiration time—0 (no time-out)
Command Modes
VLAN Config
Related Commands
Command
show
mldsnooping
set mld mrouter
Use this command to configure the VLAN ID (vlan-id) that has the multicast router
mode enabled. Use the no form of the command to disable it.
set mld mrouter vlan-id
no set mld mrouter vlan-id
Syntax Descriptions
Parameter
vlan-id
Default
MLD mrouter is disabled by default on all VLANs.
Command Modes
Interface Config
Description
The multicast router present expiration time. The range is
0–3600 seconds. A value of 0 indicates an infinite time-out;
i.e. no expiration.
Description
Displays MLD Snooping information.
Description
The ID of the VLAN to configure.
7
318
Advertisement
Table of Contents
