Storm-Control Unicast Rate - Cisco Small Business 200 Series User Manual

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Command
storm-control
unicast rate
show storm-
control

storm-control unicast rate

This command enables and configures the unicast storm recovery rate for an
interface as packets per second. If unicast storm recovery is active and the rate of
destination lookup failure packets ingressing on an interface exceeds the
configured threshold, the traffic is dropped. In Global Config mode the same rate
is set on all ports. Use the no form of command to remove the rate threshold.
storm-control unicast rate 0-14880000
no storm-control unicast rate
Syntax Descriptions
Parameter
0–14880000
Default
No unicast storm recovery rate is configured.
Command Modes
Interface Config
Global Config
Related Commands
Command
storm-control
unicast
Description
Configures the unicast storm recovery threshold for an
interface or all interfaces.
Shows storm control configuration on a port or on all ports.
Description
The unicast traffic rate, in number of packets per second,
above which traffic is dropped.
Description
Enables unicast storm recovery mode for an interface.
3
197