Show Sntp Client - Cisco Small Business 200 Series User Manual

Administration
SNTP and Time Settings
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Command
show clock

show sntp client

Use this command to display settings for the switch when it acts as an SNTP
client.
show sntp client
Command Modes
Privileged Exec
Examples
The following shows sample output for the command.
(Switch) #show sntp client
Client Supported Modes:
SNTP Version:
Port:
Client Mode:
Broadcast Poll Interval:
Client Supported
Modes
SNTP Version
Port
Client Mode
Broadcast/
Unicast Poll
Interval
Description
Displays the time and date from the system clock.
unicast broadcast
4
123
broadcast
3
Indicates whether the switch serves as a unicast client,
where it sends unicast SNTP requests to the configured
servers only, or as a broadcast client, where it accepts
time information broadcasted from SNTP servers.
The SNTP version the switch uses as a client.
The logical port number the switch uses as an SNTP
client. The default is the well-known IANA port number for
this service, 123.
Indicates whether the switch is enabled or disabled as an
SNTP client.
The number of seconds between SNTP polling messages
to broadcast or unicast SNTP servers, depending on the
client mode configuration.
2
114