Hard Disk Drive Module Status Leds; Power Supply Status Leds - Maxtor NAS 6000 Administration Manual

MaxAttach NAS 6000 Administration Guide
Power supply voltage alarm - a power supply indicates that one or more
n
voltages are out of limits.
Temperature alarm - temperature inside the enclosure has exceeded
n
programmed limits.
HDD alarm - one or more HDDs are failing. The failed drive will have its
n
Drive Status (yellow) indicator on
GREEN Unit Power-On Indicator - Normally ON
n
This is a green lamp indicating that power is on.
n
The lamp will flash (indicating not ready) until the system has completed its
n
boot-up sequence and is ready for operation.
YELLOW Drive Status Indicator - Normally OFF.
n
This is a yellow lamp indicates there is a HDD problem.
n
If there is a HDD problem this lamp will be lit.
n
If any HDD module status lamp is on, this lamp will also be on.
n
Expansion units indicate their own status and activity. However, you must start the base unit to
enable the expansion unit status indicators. The base unit's soft power switch controls the start-up
of the expansion units.

Hard Disk Drive Module Status LEDs

Each Hard Disk Drive (HDD) Module has two LED indicators on its front panel:
A green Drive Activity indicator.
n
This indicator flashes in response to drive accesses
n
A yellow Drive Status indicator.
n
This indicator is off during normal operation.
n
It lights if there is an HDD module failure.
n
When the unit's back panel AC power switch is on and the front-panel soft
n
power switch is off, all drive status indicators are on.
As the unit powers up, the indicators go off as each drive becomes ready.
n

Power Supply Status LEDs

The MaxAttach 6000 is equipped with dual power supplies. Should one supply fail, the
other takes over. Each power supply has a green AC-OK indicator and a green DC-OK
indicator.
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
11/07/01 -- Revision 2.0.03A
NOTE
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
Hard Disk Drive Module Status LEDs
26
000001628