Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
With TSC, you have full access to the MaxAttach NAS 6000 desktop and can manage it as
if you are sitting in front of a monitor attached to the MaxAttach NAS 6000. All Microsoft
Windows management tools can be used, and the Windows 2000 online Help can be
accessed.
When a user opens TSC, she or he connects to the MaxAttach NAS 6000 and starts a
session. When he or she is finished, he or she can either disconnect, and leave the session
running (to enable connecting to this session again later) or log off, which will terminate
the session and disconnect the client. Only two simultaneous sessions are allowed. Leaving
a session running takes up one license and can affect other users. If two sessions are already
running, new users will be denied access. Finally, TSC requires all connecting users to be
authenticated, which is why users must log on each time they start a session.
CLOSING TERMINAL SERVICES SESSION: Using the X in the upper right hand corner of the screen
to close the TSC does not free up the TSC session. To correctly close a TSC, go to Start >
Shutdown > Log off Administrator.
Alert Email
When an error condition occurs, the MaxAttach NAS 6000 can send an alert email
message to a designated email address. You can enable or disable alert emails, and you can
select which category of alert email you want the system to send.
Figure #75
Chapter #3 - Overview - Microsoft Windows O/S Version 2.0
11/07/01 -- Revision 2.0.03A
NOTE
Alert Email Configuration Page Screen
Chapter #3 - Overview - Microsoft Windows O/S Version 2.0
105
Maintenance Page
000001628
Advertisement
Table of Contents
