Scsi Connections Between The First And Second Expansion Units - Maxtor NAS 6000 Administration Manual

MaxAttach NAS 6000 Administration Guide
Connector Board.
4. Connect a third SCSI cable from the Mylex lower right Port 3 to the left side SCSI
Connector Board.
5. Process Branch Point:
If your system only has a single Expansion Unit, your next step below is Step
n
#6.
If your system has an additional Expansion Unit to install, skip below to Step
n
#8.
6. Add SCSI Terminator Plugs to the upper connector on each SCSI Connector Board.
7. Your SCSI Cabling is complete. Skip ahead below to section #8: - Install EMU
Cables on page 7.

SCSI Connections Between the First and Second Expansion Units

8. Connect the two left side SCSI Connector Cards with a first SCSI Cable.
Use the lower SCSI connector for all cable runs.
n
9. Connect the two center SCSI Connector Cards with a second SCSI Cable.
10. Connect the two right side SCSI Connector Cards with a third SCSI Cable.
11. Add SCSI Terminator Plugs to the upper connector on each SCSI Connector Board.
If you ordered two Expansion Units, you may end up with an extra set of unused SCSI Connector
Cards.
Chapter #1 - Installation - Rack Mounting Your NAS 6000
11/07/01 -- Revision 2.0.03A
NOTE
Chapter #1 - Installation - Rack Mounting Your NAS 6000
1: User-Supplied Materials and Services
6
000001628