Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
IP Address Configuration
Each computer on the network must have a unique IP address to send and receive data.
You can use the IP Address Configuration page to have your server appliance automatically
obtain the IP address configuration from the Dynamic Host Configuration Protocol
(DHCP) server. Alternately, you can configure the IP address(es) manually.
In addition, you can use the IP Address Configuration page to specify one or more gateway
addresses. A gateway address is the address of a local IP router residing on the same network
as the server appliance that is used to forward traffic to destinations beyond the local
network. The value in each field must be a number from 0–255.
Changing the IP address may cause the client to lose its connection with the server appliance. To
reconnect, the user must either use the new IP address or wait until the DNS server is updated.
To set or change the IP settings on the General tab
1.
On the primary navigation bar, choose Network.
2.
Choose Interfaces.
3.
Select the network connection you want to modify.
4.
In the Tasks list, choose IP.
5.
Select the General tab.
6.
Select whether to obtain the configuration automatically from the DHCP server, or
to statically configure the IP address(es).
7.
If you choose to obtain the configuration from the DHCP server, choose OK.
8.
If you have chosen to use static IP settings, enter the IP address, Subnet mask, and
Default gateway in the boxes provided.
To set or change the IP settings on the Advanced tab
1.
On the primary navigation bar, choose Network.
Chapter #5 - O/S 2.0 - Network Configuration
11/07/01 -- Revision 2.0.03A
•
AppleTalk Service Properties
NOTE
Chapter #5 - O/S 2.0 - Network Configuration
158
Network Adapter Interfaces
000001628
Advertisement
Table of Contents
