Maxtor NAS 6000 Administration Manual page 305

MaxAttach NAS 6000 Administration Guide
Gam_ev User_ev
Priority
ent ent
Number
Number Number
47 47 1
48 48 1
49 49 1
50 50 3
51 51 3
52 52 3
53 53 3
54 54 3
55 55 3
56 56 3
57 57 1
58 58 3
59 59 3
60 60 2
61 61 4
96 96 1
128 128 4
129 129 4
130 130 4
131 131 2
132 132 2
133 133 4
134 134 1
135 135 2
136 136 4
137 137 4
Chapter #14 - Appendix - Disk Array Error Codes
11/07/01 -- Revision 2.0.03A
Table #1 - Mylex Error Codes (Sheet 3 of 8)
Severity
Level
Serious A hard disk failed because device was not found on start up.
Serious A hard disk failed because write operation of the 'Configuration On Disk'
failed.
Serious A hard disk failed because write operation of 'Bad Data Table' failed.
Warning Physical device status changed to offline.
Warning Physical device status changed to Hot Spare.
Warning Physical device status changed to rebuild.
Warning Physical device ID did not match.
Warning Physical device failed to start.
Warning Physical device negotiated different offset than config.
Warning Physical device negotiated different bus width than config.
Serious Physical drive missing on startup.
Warning Rebuild startup failed due to lower disk capacity.
Warning Physical drive is switching from a channel to the other channel.
Error Temporary-Dead physical drive is automatically made online.
Information A standby rebuild has started.
Serious Device Loop Id Conflict (Soft Addressing) Detected.
Information Consistency check is started.
Information Consistency check is finished.
Information Consistency check is cancelled.
Error Consistency check on logical drive error.
Error Consistency check on logical drive failed.
Information Consistency check failed due to physical device failure.
Serious Logical drive has been made offline.
Error Logical drive is critical.
Information Logical drive has been placed online.
Information An automatic rebuild has started on logical drive.
Chapter #14 - Appendix - Disk Array Error Codes
Description
285
Mylex Error Codes Table
000001628