Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
Renaming a Connection
To rename an interface connection
1.
From the primary navigation bar, choose Network.
2.
Choose Interfaces.
3.
Select the interface connection you want to rename.
4.
In the Tasks list, choose Rename.
5.
In the New connection name box, type the new name of the interface connection.
6.
Choose OK.
AppleTalk Local Area Network Connection
Use the AppleTalk LAN Connection page to specify which network adapter can receive
inbound AppleTalk connections and in which AppleTalk zone the MaxAttach will appear.
Configuring an AppleTalk Network Connection
To configure a network interface for AppleTalk
1.
Log in to the MaxAttach as administrator.
2.
Click Network on the main menu bar.
3.
Select Interfaces. The Interfaces page displays.
4.
Select the interface you want to configure by clicking a radio button in the
Description column.
5.
On the Tasks list, click AppleTalk. The AppleTalk Configuration page displays.
6.
Set the Enable inbound AppleTalk connections on this adapter checkbox to
permit the adapter to accept inbound AppleTalk traffic. Note that only one adapter
per system can be so enabled. If another adapter is already enabled for inbound
AppleTalk traffic, it will be automatically disabled.
7.
If your network is organized into AppleTalk zones, use the pull-down list to select
Chapter #5 - O/S 2.0 - Network Configuration
11/07/01 -- Revision 2.0.03A
Chapter #5 - O/S 2.0 - Network Configuration
AppleTalk Local Area Network Connection
146
000001628
Advertisement
Table of Contents
