MaxAttach NAS 6000 Administration Guide
LCD Alerts: Messages are displayed on a small liquid crystal display (LCD) on the
n
MaxAttach front panel.
Web UI Alerts: Error messages and condition alerts that you access from the device's
n
LED Status Indicators
LED (light emitting diode) status indicators are available on the front panels of the base unit
and each installed expansion unit and provide general information about:
Activity and condition of the hard disk drive modules (on all enclosures)
n
Status of the unit's power supplies (on all enclosures)
n
Over-all system status (only on the Base Unit enclosure).
n
Figure #9
Front Panel LEDS
There are three LED indicators in the lower right-hand corner of the main front panel that
indicate general system status. These are the System Status Alarm indicator, the Power On
indicators, and the Drive Status indicator.
BLUE System Status Alarm Indicator - Normally OFF.
n
This is a blue lamp which reports overall system status. The lamp remains off
n
unless there is an alarm from a source below.
Blower or fan alarm - the blower or a fan is indicating an underspeed condition.
n
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
11/07/01 -- Revision 2.0.03A
NAS 6000 LED Locations and Functions
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
25
Front Panel LEDS
000001628