Cabinet-Mount System Or Single Base Unit Rack Mount System; Scsi Connections Between Base Unit And First Expansion Unit - Maxtor NAS 6000 Administration Manual

MaxAttach NAS 6000 Administration Guide

Cabinet-Mount System or Single Base Unit Rack Mount System

1. Process Branch Point:
If your system has a Base Unit and one or two Expansion Units, perform the
n
next step in this process immediately below in the section titled SCSI
Connections Between Base Unit and First Expansion Unit on page 5.
If you have a cabinet-mounted stem or a single Base Unit rack-mount system,
n
no SCSI cabling is required. Skip ahead below to the section titled Install
EMU Cables on page 7.
Figure #3

SCSI Connections Between Base Unit and First Expansion Unit

2. Connect a SCSI cable from the Mylex upper left Port 0 connector to the right side
SCSI Connector Board.
3. Connect a second SCSI cable from the Mylex upper right Port 1 to the center SCSI
Chapter #1 - Installation - Rack Mounting Your NAS 6000
11/07/01 -- Revision 2.0.03A
NAS 6000 SCSI Cable Connections
Chapter #1 - Installation - Rack Mounting Your NAS 6000
1: User-Supplied Materials and Services
5
000001628