MaxAttach NAS 6000 Administration Guide
If you want to reconfigure drive H:\, you must first disassemble drive J:\, then
n
drive I:\, and finally drive H:\. The disassembly process takes the drives out of
their previous arrays and leaves them in the system with an "unconfigured
status."
During this process, all user data on the array is destroyed.
n
At this point, you can now reconfigure drive H:\ into a new configuration.
n
Then you would have to reconfigure drive I:\ to its original configuration
n
followed by reconfiguring drive J:\.
12. Once the drive arrays have been reconfigured, use the Max O/S Web User Interface
(UI) to reconfigure network, users, group, folder, and share option.
Chapter #4 - Overview - NAS 6000 Disk Array
11/07/01 -- Revision 2.0.03A
Chapter #4 - Overview - NAS 6000 Disk Array
Re-Configuring Your MaxAttach NAS 6000 Drive Arrays
130
000001628