Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
8.
If you have chosen to use static IP settings, enter the IP address, Subnet mask, and
Default gateway in the boxes provided.
Changing IP Settings on the Advanced Tab
To set or change the IP settings on the Advanced tab
1.
On the primary navigation bar, choose Network.
2.
Choose Interfaces.
3.
Select the network connection you want to modify.
4.
In the Tasks list, choose IP.
5.
Select the Advanced tab.
6.
In the IP address box on the right, type the IP address, and then choose Add.
7.
If you have a local area connection, type the appropriate mask information in the
Subnet mask box.
A subnet mask is a 32-bit number that is notated by using four numbers from
n
0–255, separated by periods.
Typically, default subnet mask numbers use either 0 or 255 as values, such as
n
255.255.255.0.
However, other numeric values can appear, indicating that the subnet is
n
configured for a single TCP/IP network.
This number, with a value other than 0 or 255, is combined with the IP address
n
number to identify the network on which your computer resides.
8.
If necessary, update the IP Connection Metric.
The metric indicates the cost of using the routes associated with this connection
n
and becomes the value in the Metric column for those routes in the IP routing
table.
If there are multiple routes to a destination the route with the lowest metric is
n
used. The default value is 1.
9.
Repeat steps 1–3 for any other IP addresses you wish to add.
Chapter #5 - O/S 2.0 - Network Configuration
11/07/01 -- Revision 2.0.03A
Chapter #5 - O/S 2.0 - Network Configuration
148
IP Address Configuration
000001628
Advertisement
Table of Contents
