Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
6.
Choose OK.
Setting NetWare Share Properties
Use these instructions to specify sharing properties for an existing Novel NetWare Share.
If the share does not yet exist, create the share first by following the procedures in Adding A Novell
NetWare Share.
To set NetWare sharing properties
1.
On the primary navigation bar, choose Shares.
2.
On the Shares page, choose Shares.
3.
Select the share for which you want to add NetWare client access, and then choose
Properties from the Tasks list. The Share Properties of user page appears.
4.
Click the NetWare Sharing tab. This opens a Terminal Services window.
5.
Click Yes to clear the warning message.
6.
Log into Windows 2000. The Shared Folders dialog box appears.
7.
In the Shared Folder pane, locate the share you wan to modify.
Note that if a share is enabled for more than one protocol, there will be multiple shares with the
same name. Be sure to select the share for NetWare as shown in the Type column.
8.
Double click the share you want to modify. The </share name> Properties dialog box
appears.
9.
On the General tab, set the limit to the number of users.
10. If you want to limit access, select the Share Permissions tab and either remove the
everyone group or modify its permissions (the default permission levels for
everyone allows full control of the share). Then add any users or groups for whom
you want to grant access.
Chapter #8 - O/S 2.0 - Folders and Shares
11/07/01 -- Revision 2.0.03A
NOTE
NOTE
Chapter #8 - O/S 2.0 - Folders and Shares
202
Managing Shares
000001628
Advertisement
Table of Contents
