Chapter #1 - Installation - Rack
If you have a cabinet-mounted version of the MaxAttach NAS 6000, skip this section and continue
with the next chapter.
Chapter Outline
This chapter provides an in depth description of installation requirements for MaxAttach
NAS 6000 rack-mountable systems. It also describes how to get your MaxAttach NAS
6000 mechanically ready by performing the following tasks:
Install the user-supplied equipment rack.
n
Install the user-supplied AC power strips.
n
Install all MaxAttach equipment enclosure shelves into the rack.
n
Install the MaxAttach SCSI connector cables for the hard disk drives.
n
Install the MaxAttach Serial Port connector cables for the Environmental Monitoring
n
Unit (EMU).
Install the Ethernet Network Interface Card (NIC) cables between the MaxAttach
n
NICs and your network.
Prepare the MaxAttach for power up.
n
1:
User-Supplied Materials and Services
The following user-supplied materials are required:
A standard 19" equipment rack.
n
The minimum rack vertical size depends on the configuration of your
n
MaxAttach.
Revision 2.0.03A - 11/07/01
Mounting Your NAS 6000
NOTE
MaxAttach NAS 6000
1
000001628