ZyXEL Communications Vantage Report User Manual page 654

Appendix C ZyNOS Log Descriptions
Table 306 Wireless Logs
LOG MESSAGE
WLAN STA Association List
Full
WLAN STA Association Again The SSID and time of association were updated for an
Table 307 IPSec Logs
LOG MESSAGE
Discard REPLAY packet
Inbound packet
authentication failed
Receive IPSec packet,
but no corresponding
tunnel exists
Rule <%d> idle time out,
disconnect
WAN IP changed to <IP>
Inbound packet
decryption failed
Cannot find outbound SA
for rule <%d>
Rule [%s] sends an echo
request to peer
Rule [%s] receives an
echo reply from peer
Delete all tunnels
Table 308 IKE Logs
LOG MESSAGE
Active connection allowed
exceeded
Start Phase 2: Quick Mode
Verifying Remote ID failed:
654
DESCRIPTION
The maximum number of associated wireless clients has
been reached.
wireless station that was already associated.
DESCRIPTION
The router received and discarded a packet with an incorrect
sequence number.
The router received a packet that has been altered. A third
party may have altered or tampered with the packet.
The router dropped an inbound packet for which SPI could
not find a corresponding phase 2 SA.
The router dropped a connection that had outbound traffic
and no inbound traffic for a certain time period. You can use
the "ipsec timer chk_conn" CI command to set the time
period. The default value is 2 minutes.
The router dropped all connections with the "MyIP"
configured as "0.0.0.0" when the WAN IP address changed.
Please check the algorithm configuration.
A packet matches a rule, but there is no phase 2 SA for
outbound traffic.
The device sent a ping packet to check the specified VPN
tunnel's connectivity.
The device received a ping response when checking the
specified VPN tunnel's connectivity.
The device disconnected all IPSec tunnels.
DESCRIPTION
The IKE process for a new connection failed because
the limit of simultaneous phase 2 SAs has been
reached.
Phase 2 Quick Mode has started.
The connection failed during IKE phase 2 because the
router and the peer's Local/Remote Addresses don't
match.
Vantage Report User's Guide