ZyXEL Communications Vantage Report User Manual page 656

Appendix C ZyNOS Log Descriptions
Table 308 IKE Logs (continued)
LOG MESSAGE
Remote IP <Remote IP> /
<Remote IP> conflicts
Phase 1 ID type mismatch
Phase 1 ID content mismatch
No known phase 1 ID type
found
ID type mismatch. Local /
Peer: <Local ID type/Peer ID
type>
ID content mismatch
Configured Peer ID Content:
<Configured Peer ID Content>
Incoming ID Content:
<Incoming Peer ID Content>
Unsupported local ID Type:
<%d>
Build Phase 1 ID
Adjust TCP MSS to %d
Rule <%d> input idle time
out, disconnect
XAUTH succeed! Username:
<Username>
XAUTH fail! Username:
<Username>
XAUTH succeed! Remote user:
<Username>
XAUTH fail! Remote user:
<Username>
XAUTH succeed! My name:
<Username>
XAUTH fail! My name:
<Username>
Rule[%d] Phase 1 negotiation
mode mismatch
Rule [%d] Phase 1 encryption
algorithm mismatch
656
DESCRIPTION
The security gateway is set to "0.0.0.0" and the router
used the peer's "Local Address" as the router's
"Remote Address". This information conflicted with
static rule #d; thus the connection is not allowed.
This router's "Peer ID Type" is different from the peer
IPSec router's "Local ID Type".
This router's "Peer ID Content" is different from the
peer IPSec router's "Local ID Content".
The router could not find a known phase 1 ID in the
connection attempt.
The phase 1 ID types do not match.
The phase 1 ID contents do not match.
The phase 1 ID contents do not match and the
configured "Peer ID Content" is displayed.
The phase 1 ID contents do not match and the
incoming packet's ID content is displayed.
The phase 1 ID type is not supported by the router.
The router has started to build the phase 1 ID.
The router automatically changed the TCP Maximum
Segment Size value after establishing a tunnel.
The tunnel for the listed rule was dropped because
there was no inbound traffic within the idle timeout
period.
The router used extended authentication to
authenticate the listed username.
The router was not able to use extended
authentication to authenticate the listed username.
The router used extended authentication to
authenticate the listed remote username.
The router was not able to use extended
authentication to authenticate the listed remote
username.
The router used extended authentication to
authenticate the listed username.
The router was not able to use extended
authentication to authenticate the listed username.
The listed rule's IKE phase 1 negotiation mode did not
match between the router and the peer.
The listed rule's IKE phase 1 encryption algorithm did
not match between the router and the peer.
Vantage Report User's Guide