ZyXEL Communications Vantage Report User Manual page 575

The fields above are described in the following table.
Table 257 System Setting > Rule-based Alert > Add/Edit > Service
LABEL
Condition
Traffic.. KBytes/s
Period.. minutes
See Section Table 252 on page 568
this screen.
Vantage Report User's Guide
DESCRIPTION
Select Bandwidth in this field.
Set your filters according to how much system resources are
being consumed by monitored devices. The following parameters
can be used.
• >= - Select this if you want to be alerted when a device uses
resources greater than or equal to the value you set.
• <= - Select this if you want to be alerted when a device uses
resources less than or equal to the value you set.
• < - Select this if you want to be alerted when a device uses
resources greater than the value you set.
• > - Select this if you want to be alerted when a device uses
resources less than the value you set.
For example, select >= and set the percentage value to 100
KByte/s. This means Vantage Report sends an alert once a
monitored device uses or exceeds 100 KBytes/s bandwidth for a
set time (see Period.. minutes field below).
Set this to the number of minutes the condition persists before
Vantage Report sends out an alert.
Using the previous example, you can set the period to 5 minutes.
This means that if the device reaches or exceeds 100 KByte/s of
bandwidth for 5 minutes, Vantage Report sends out an alert.
for descriptions of other table fields found in
Chapter 14 System Setting
575