ZyXEL Communications Vantage Report User Manual page 570

Chapter 14 System Setting
Table 253 System Setting > Rule-based Alert > Add/Edit > Port Usage
LABEL
Traffic.. KBytes/s
Period.. minutes
See Section Table 252 on page 568
this screen.
14.7.1.3 Interface Usage
Use this screen to configure an alert rule for interface type (such as Ethernet,
VLAN or Bridge) used by the selected device(s).
Note: This condition filter only applies to the ZLD platform type.
Click System Setting > Rule-based Alert then either click on the link of the
existing Rule Name or click Add. Select Interface Usage in the Condition field.
The fields in the Filter section change to the following.
Figure 274 System Setting > Rule-based Alert > Add/Edit > Interface Usage
570
DESCRIPTION
Set your filters according to how much system resources are
being consumed by monitored devices. The following parameters
can be used.
• >= - Select this if you want to be alerted when a device uses
resources greater than or equal to the value you set.
• <= - Select this if you want to be alerted when a device uses
resources less than or equal to the value you set.
• < - Select this if you want to be alerted when a device uses
resources greater than the value you set.
• > - Select this if you want to be alerted when a device uses
resources less than the value you set.
For example, choose Port1 port and Tx direction, select >= and
set the percentage value to 100 KByte/s. This means Vantage
Report sends an alert once a monitored device uses or exceeds
100 KBytes/s outgoing traffic on port 1 for a set time (see
Period.. minutes field below).
Set this to the number of minutes the condition persists before
Vantage Report sends out an alert.
Using the previous example, you can set the period to 5 minutes.
This means that if the device reaches or exceeds 100 KByte/s of
outgoing port traffic for 5 minutes, Vantage Report sends out an
alert.
for descriptions of other table fields found in
Vantage Report User's Guide