ZyXEL Communications Vantage Report User Manual page 564

Chapter 14 System Setting
The fields are described in the following table.
Table 250 System Setting > Notification > Add/Edit
LABEL
Notification Name
Severity
Notification
Description
Email
Email Status
add
Destination E-mail
Address
SMS-SMTP
SMS-SMTP Status
To Address
Message Subject
564
DESCRIPTION
Type up to 30 alphanumeric characters for the name of the
notification. Underscores (_) are allowed.
Select the severity of the notification. The available options are:
• FATAL - System is unusable
• WARN - Warning conditions
• INFO - Informational messages
This shows the basic information for the notification.
Select Active to enable the Vantage Report to send this type of
notification to the configured e-mail address(es) in the Destination
E-mail Address field. Alternatively, select Paused to disable it.
Type a valid e-mail address and click this to add it to the Destination
E-mail Address list. Repeat to add more than one e-mail addresses.
This is a list of receiver e-mail addresses. You can select an e-mail
address and then click remove to delete it from the list.
Select Active to enable the Vantage Report to send this type of
notification to the configured address(es) below using E-mail Short
Message Service (SMS). Alternatively, select Paused to disable it.
Type one or more valid SMS addresses. Use a comma (,) to separate
multiple addresses.
An SMS address is usually your cell phone number plus an '@' and
your SMS service provider's domain name. For example,
1234567890@abcdefg.com. Check your service provider if you are
not sure about this.
Type up to 50 printable characters for the mail subject. Spaces are
allowed. Mouse over the information icon to see what variables you
can use for the mail subject. The available variables are:
%msg: Use this to show the content of the notification.
%level: Use this to show the severity level of the notification.
%server: Use this to show the IP address of the mail server used to
send the notification.
%title: Use this to show the title of the notification.
%category: Use this to show the category of the notification.
Vantage Report User's Guide