ZyXEL Communications Vantage Report User Manual page 569

Table 252 System Setting > Rule-based Alert > Add/Edit > CPU/Memory/Session
Usage
LABEL
Second Alert
after.. minutes
Third alert after..
minutes
Select Devices
Notification
Notification
Choose
Apply
Reset
Cancel
14.7.1.2 Port Usage
Use this screen to configure an alert rule for port usage.
Note: This condition filter only applies to the ZLD platform type.
Click System Setting > Rule-based Alert then either click on the link of the
existing Rule Name or click Add. Select Port Usage in the Condition field.
The fields in the Filter section change to the following.
Figure 273 System Setting > Rule-based Alert > Add/Edit > Port Usage
The fields above are described in the following table.
Table 253 System Setting > Rule-based Alert > Add/Edit > Port Usage
LABEL
Condition
Port
Direction
Vantage Report User's Guide
DESCRIPTION
Specify when you want Vantage Report to send a second e-mail
notification. Enter the number of minutes between 1 to 60. Enter 0 to
disable this.
Specify when you want Vantage Report to send a third e-mail
notification. Enter the number of minutes between 1 to 60. Enter 0 to
disable this.
Check which devices the rule applies to. Click Select All if you want
the conditions you set to be monitored for all devices.
Select a notification profile that applies to this rule. Click the Setting
icon to take you to the System Setting > Notification screen (see
Section 14.6 on page 561) for managing notification profiles.
Click this to add the rule or apply the edits to an existing rule.
Click this to leave all the fields blank or back to the original values if
you are editing a previous configuration.
Click this to go back to the Rule-Based Alert screen.
DESCRIPTION
Select Port Usage in this field.
Select which port in the device you want to monitor.
Select if you want to check outgoing (Tx) or incoming (Rx) traffic.
You can also choose both (Tx+Rx).
Chapter 14 System Setting
569