Table 288 Interface Logs (continued)
LOG MESSAGE
Please type phone
number of interface
AUX first then dial
again.
Please type phone
number of Interface
AUX first then
disconnect again.
Interface %s will
reapply because Device
HA become active
status.
Interface %s will
reapply because Device
HA is not running.
Interface %s will stop
connect because Device
HA become standby
status.
Create interface %s
has been failed.
Base interface %s is
disabled. Interface %s
is disabled now.
Interface %s has been
changed.
Interface %s has been
added.
Interface %s is
enabled.
Interface %s is
disabled.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
Interface %s links
down. Default route
will not apply until
interface %s links up.
Vantage Report User's Guide
Appendix B ZyWALL USG Series and ZyWALL 1050 Log Descriptions
DESCRIPTION
A user tried to dial the AUX interface, but the AUX interface
does not have a phone number set.
The AUX interface does not have a phone number set and a
user tried to use the disconnect aux command.
Device-ha became active and is using a PPP base interface,
the PPP interface must reapply, %s is the interface name.
Device-ha was deleted and free PPP base interface, PPP
interface must reapply, %s is the interface name.
When device-ha is stand-by and use PPP base interface, PPP
interface connection will stop, %s: interface name.
When PPP can't running fail, %s: interface name.
When user disable ethernet, vlan or bridge interface and this
interface is base interface of PPP or virtual interface. PPP and
virtual will disable too. 1st %s is interface name, 2nd %s is
interface.
An administrator changed an interface's configuration. %s:
interface name.
An administrator added a new interface. %s: interface name.
An administrator enabled an interface. %s: interface name.
An administrator disabled an interface. %s: interface name.
An administrator configured a PPP interface, PPP interface
MTU > (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface ans peer will not receive correct PPP packets. 1st
%s: PPP interface name, 2nd %s: ethernet interface name.
An administrator configured ethernet, vlan or bridge and this
interface is base interface of PPP interface. PPP interface MTU
> (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and peer will not receive correct PPP packets.1st %s:
Ethernet interface name, 2nd %s: PPP interface name.
An administrator set a static gateway in interface but this
interface is link down. At this time the configuration will be
saved but route will not take effect until the link becomes
up.1st %s: interface name, 2nd %s: interface name.
639