ZyXEL Communications Vantage Report User Manual page 634

Appendix B ZyWALL USG Series and ZyWALL 1050 Log Descriptions
Table 285 Routing Protocol Logs (continued)
LOG MESSAGE
OSPF on interface %s
has been stopped
because Device-HA
binds this interface.
Area %s cannot be
removed. This area is
in use.
Invalid OSPF %s
authentication of area
%s.
Invalid OSPF virtual-
link %d md5
authentication of area
%s.
Invalid OSPF virtual-
link %s text
authentication of area
%s.
Invalid OSPF virtual-
link %s authentication
of area %s.
Invalid OSPF md5
authentication on
interface %s.
Invalid OSPF text
authentication on
interface %s.
Interface %s does not
belong to any OSPF
area.
Invalid OSPF
authentication of area
%s on interface %s.
Table 286 NAT Logs
LOG MESSAGE
The NAT range is full
%s FTP ALG has
succeeded.
Extra signal port of
FTP ALG has been
modified.
634
DESCRIPTION
Device-HA is currently running on the interface %s, so all the
local service have to be stopped including OSPF. %s: Interface
Name
One or more interfaces are still using this area, so area %s
cannot be removed. %s: OSPF Area
OSPF md5 or text authentication has been set without setting
md5 authentication id and key, or text authentication key first.
Virtual-link %s md5 authentication has been set without
setting md5 authentication id and key first. %s: Virtual-Link
ID
Virtual-link %s text authentication has been set without
setting text authentication key first. %s: Virtual-Link ID
Virtual-link %s authentication has been set to same-as-area
but the area has invalid authentication configuration. %s:
Virtual-Link ID
Invalid OSPF md5 authentication is set on interface %s. %s:
Interface Name
Invalid OSPF text authentication is set on interface %s. %s:
Interface Name
Interface %s has been set OSPF authentication same-as-area,
however the interface does not belong to any OSPF area. %s:
Interface Name
Interface %s has been set OSPF authentication same-as-area,
however the area has invalid text authentication
configuration. %s: Interface Name
DESCRIPTION
The NAT mapping table is full.
The FTP Application Layer Gateway (ALG) has been turned on
or off.
%s: Enable or Disable
Extra FTP ALG port has been changed.
Vantage Report User's Guide