ZyXEL Communications Vantage Report User Manual page 616

Appendix B ZyWALL USG Series and ZyWALL 1050 Log Descriptions
Table 276 IKE Logs (continued)
LOG MESSAGE
Tunnel [%s] IKE
Negotiation is in
process
VPN gateway %s was
disabled
VPN gateway %s was
enabled
XAUTH fail! My name:
%s
XAUTH fail! Remote
user: %s
XAUTH succeed! My
name: %s
XAUTH succeed! Remote
user: %s
Dynamic Tunnel
[%s:%s:0x%x:%s] built
successfully
Dynamic Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel [%s:%s:0x%x:%s]
built successfully
Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel [%s:%s]
1 pre-shared key
mismatch
Tunnel [%s:%s]
Recving IKE request
Tunnel [%s:%s]
Sending IKE request
Tunnel [%s:0x%x] is
disconnected
Tunnel [%s] rekeyed
successfully
616
DESCRIPTION
%s is the tunnel name. When IKE request is already sent but
still attempting to dial a tunnel.
%s is the gateway name. An administrator disabled the VPN
gateway.
%s is the gateway name. An administrator enabled the VPN
gateway.
%s is the my xauth name. This indicates that my name is
invalid.
%s is the remote xauth name. This indicates that a remote
user's name is invalid.
%s is the my xauth name. This indicates that my name is
valid.
%s is the remote xauth name. This indicate that a remote
user's name is valid
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name and tunnel name.
Phase
When negotiating phase-1, the pre-shared keys did not
match.
The variables represent the phase 1 name and tunnel name.
The device received an IKE request.
The variables represent the phase 1 name and tunnel name.
The device sent an IKE request.
The variables represent the tunnel name and the SPI of a
tunnel that was disconnected.
%s is the tunnel name. The tunnel was rekeyed successfully.
Vantage Report User's Guide