Connecting Ac Power Cords To The Acx1100 Router; Figure 19: Grounding Points On The Acx1000 And Acx1100 Router - Juniper ACX1000 Hardware Manual

ACX1000 and ACX1100 Universal Access Router Hardware Guide
Related
Documentation

Connecting AC Power Cords to the ACX1100 Router

42
Secure the grounding cable lug with the washers and screws. The holes are sized for
8.
SAE 10-32 screws. Apply 4.34 lb-in. (0.49 Nm) of torque to each screw. Do not
overtighten the screw. (Use a number 2 Phillips screwdriver.)
CAUTION: Ensure that each grounding cable lug seats flush against the
surface of the grounding points as you are tightening the screws. Ensure
that each screw is properly threaded into the grounding points. Applying
installation torque to the screw when improperly threaded may result in
damage to the terminal.
CAUTION: The maximum torque rating of the grounding screws on the
router is 4.34 lb-in. (0.49 Nm). The grounding screws may be damaged if
excessive torque is applied. Use only a torque-controlled driver to tighten
screws. Use an appropriately sized driver, with a maximum torque capacity
of 5 lb-in. or less. Ensure that the driver is undamaged and properly
calibrated and that you have been trained in its use. You may wish to use
a driver that is designed to prevent overtorque when the preset torque
level is achieved.
Dress the grounding cable, and verify that it does not touch or block access to router
9.
components, and that it does not drape where people could trip on it.

Figure 19: Grounding Points on the ACX1000 and ACX1100 Router

1— Grounding lug
Installing and Connecting an ACX1000 or ACX1100 Router Overview on page 31
Connecting DC Power Cables to the ACX1000 or ACX1100 Router on page 43
Preventing Electrostatic Discharge Damage to an ACX1000 or ACX1100 Router on
page 82
To connect AC power to the router, you need the following tools:
ESD grounding wrist strap
1
2
2— SAE 10-32 screws and washers
Copyright © 2013, Juniper Networks, Inc.