Replacing An Acx1000 Or Acx1100 Transceiver; Removing An Acx1000 Or Acx1100 Transceiver - Juniper ACX1000 Hardware Manual

Replacing an ACX1000 or ACX1100 Transceiver

Removing an ACX1000 or ACX1100 Transceiver

Copyright © 2013, Juniper Networks, Inc.
Small form-factor pluggable transceivers (SFPs) are optical transceivers that are installed
in the front panel of the ACX1000 and ACX1100 router. Transceivers are hot-insertable
and hot-removable.
Removing an ACX1000 or ACX1100 Transceiver on page 71
1.
Installing an ACX1000 or ACX1100 Transceiver on page 72
2.
Removing a transceiver does not interrupt router functioning, but the removed transceiver
no longer receives or transmits data.
To remove a transceiver (see
Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat,
1.
and a rubber safety cap for the transceiver.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Label the cables connected to the transceiver so that you can reconnect them correctly
3.
later.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Remove the cable connector from the transceiver.
4.
Pull the ejector handle out from the transceiver to unlock the transceiver.
5.
CAUTION: Make sure that you open the ejector handle completely until
you hear it click. This action prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3
6.
cm) out of the router.
Using your fingers, grasp the body of the transceiver, and pull it the rest of the way
7.
out of the router.
Chapter 15: Replacing ACX1000 and ACX1100 Hardware Components
Figure 29 on page 72):
71