Connecting The Router To A Management Console Or Auxiliary Device; Figure 24: Routing Engine Console And Auxiliary Cable Connector; Figure 25: Auxiliary And Console Connections - Juniper ACX1000 Hardware Manual

ACX1000 and ACX1100 Universal Access Router Hardware Guide

Connecting the Router to a Management Console or Auxiliary Device

Related
Documentation
48
You can connect a console, laptop, modem, or other auxiliary device by connecting a
serial cable to the port on the front panel labeled
serial cable with an RJ-45 connector, which is provided with the router.
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable into the
2.
panel (Figure 24 on page 48
ports.)
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Bits per second—9600
Data bits—8
Parity—None
Stop bits—1
Flow control—None

Figure 24: Routing Engine Console and Auxiliary Cable Connector

Figure 25: Auxiliary and Console Connections

CONSOLE/AUX
port
Installing and Connecting an ACX1000 or ACX1100 Router Overview on page 31
General Site Guidelines for ACX Series Routers on page 30
Management Port Connector Pinout Information for ACX Series Routers on page 133
Initially Configuring the ACX1000 or ACX1100 Router on page 49
CONSOLE/AUX
AUX port or
shows the connector. Figure 25 on page 48
Console Server
. This port accepts a
CONSOLE port on the front
shows the
PC
Copyright © 2013, Juniper Networks, Inc.